Ultra-light EPP foam spinner for model aircraft with a propeller mounted with a prop saver (not applicable when propeller is mounted with a nut). A plastic insert is inserted into the hole in the spinner, which is connected with the hole in the propeller by a short shaft made of plastic tube 3.2/2mm. There must be a 3mm hole in the propeller.
Use the spacer ring when hole in the propeller is larger (this part is usually an propeller accessory). Smaller hole can be easily adjusted with the tip of the scissors, no drilling needed.
Insert the shaft into the hole in the propeller and add the plastic insert. In order to hold the spinner well, the coupling must be very stiff. Place the spinner on the plastic insert. No glue needed. But if you want, you can glue the plastic insert into the spinner - be careful to center it!
Suitable for GWS propellers and similar.
Do not use in powerful and high-speed motors!
Weight (complete): 0.78g (white), 0.93g (black)
Set includes:
- EPP cone (diameter 44.5mm, length 41mm)
- Plastic insert
- Plastic tube 3.2/2-80mm
Note: The spinner surface is not completely smooth. There may be minor burrs on the edges. This is not a defect, but a property given by the method of manufacture.
