SA struts for the installation of the next floor of the track. The SA posts are 200 mm high and have a special design that provides the necessary strength to be used in any location for the installation of any I-Track system board. The I-Track plates are self-supporting - they have a special construction that guarantees rigidity and very low weight. The reinforcing crossbars have holes that can be used for cable installation. Holes in the underside of the board ensure access to all locations. So in a moment, using SA posts, you can easily create a bridging section of track or create a "hidden station" at any point on the track. Any board from the I-Track range can be used. You can also use the SA posts to install the boards side by side or on top of each other to create several levels as required.
Transition piece.
For curves with a radius of less than 20 cm, use the FLEXI transition piece HCT9403T and continue with FLEXI segments 2,85 cm HCT9402F.
This increases the spacing of the guide magnetic strips to 1 cm, allowing longer vehicles and buses to pass each other safely in curves.
At the end of the curve, use the same transition piece again to return to the standard spacing of the guide magnetic strips of 4 cm on straight sections.
Transition piece.
For curves with a radius of less than 20 cm, use the FLEXI transition piece HCT9404T and continue with FLEXI segments 3.35 cm HCT9404F.
This increases the spacing of the guide magnetic strips to 1.5 cm, allowing longer vehicles and buses to pass each other safely in curves.
At the end of the curve, use the same transition piece again to return to the standard spacing of the guide magnetic strips of 4 cm on straight sections.
Transition piece.
For curves with a radius of less than 20 cm, use the FLEXI transition piece HCT9402T and continue with FLEXI segments 2,85 cm HCT9402F.
This increases the spacing of the guide magnetic strips to 1 cm, allowing longer vehicles and buses to pass each other safely in curves.
At the end of the curve, use the same transition piece again to return to the standard spacing of the guide magnetic strips of 4 cm on straight sections.
I-Track roadbed plates for the Car Motion System – including crossing, curve, and straight plates.
The street and crossing roadbed plates of the I-Track roadbed system are made of a special 1 mm material and are glued directly onto the base surface – either with traditional wood glue or with Hacker’s industrial CA superglue.
The roadbed plates are factory-prepared with perfectly and precisely pre-cut grooves for installing the 3×1 mm Viessmann magnetic strip (item no. V8430). The crossing roadbed plates additionally feature pre-cut openings for mounting the mechanical Viessmann turnouts (item no. V8448 or V8445). This makes installing the magnetic strip extremely easy.
At the turnout position, simply drill a 35 mm hole into the baseboard using a step drill. The mechanical turnout is then mounted on the underside of the baseboard using the I-Track Holder W (item no. HCT8408W).
I-Track roadbed plates for the Car Motion System – including crossing, curve, and straight plates.
The street and crossing roadbed plates of the I-Track roadbed system are made of a special 1 mm material and are glued directly onto the base surface – either with traditional wood glue or with Hacker’s industrial CA superglue.
The roadbed plates are factory-prepared with perfectly and precisely pre-cut grooves for installing the 3×1 mm Viessmann magnetic strip (item no. V8430). The crossing roadbed plates additionally feature pre-cut openings for mounting the mechanical Viessmann turnouts (item no. V8448 or V8445). This makes installing the magnetic strip extremely easy.
At the turnout position, simply drill a 35 mm hole into the baseboard using a step drill. The mechanical turnout is then mounted on the underside of the baseboard using the I-Track Holder W (item no. HCT8408W).
